logo-01

Digital weighing indicator DY910 series

  • Input signal: -14~14mV, matched with 4-wire strain sensor
  • Input sensitivity: 0.1uV/d
  • Non-linearity: ±0.01%F S (measurement speed 15 times/second)
  • Zero adjustment range: -10~10mV
  • Gain input range: 1~12mV
  • Product name: Digital weighing indicator DY910 series
  • Can be customized on request
Share on facebook
Share on twitter
Share on linkedin

External Dimension

Parameters Table

External power adapter
Input: AC 90~260V, 50Hz or 60Hz
Output: DC 12V/2A, positive inside the interface and negative outside
Note: Do not use the power adapter not matched with this machine
  Anti-interference     
IEC61000-4-2 (Electrostatic Discharge), Class III, IEC61000-4-4 (Electrical Fast Transient Burst), Class III, IEC61000-4-5 (Surge), Class III. Not applicable when powered by built-in battery
Built-in battery
The continuous use time is about 18~36 hours, depending on the way of use, and the charging time is about 4~8 hours
The standby time is about 4~8 days, and the lifespan is not less than 1000 full charge and discharge cycles
Dielectric strength
2000V AC (Test condition: 50/60Hz, 1 minute).
Not applicable when powered by built-in battery
Insulation resistance
≥100MΩ (500V DC MEGA reference). Not applicable when powered by built-in battery
input signal
Proportional measurement with 4-wire strain sensor
-14 ~ 14mV
Protection class
IP65 (Product front panel protection) (GB/T42-2008)
Measurement and control speed
15, 120, 240, 480, 960, 1920 times/sec (set by parameters)
Input sensitivity
0.1uV / d
Conversion method
Sigma-Delta
Zero adjustment range
-10~10 mV
Nonlinear
±0.01%F•S (measurement speed 15 times/second)
  Gain input range   
1 ~12 mV
Highest display accuracy
1/100000
Sensor power
DC 5V±2%100mAMAX
Alarm Output
2-point OC gate output, ≤35mA
gain drift
< 10 ppm/℃ (When connecting the sensor, you must use the matching terminal connector, otherwise the temperature drift characteristic will be deteriorated)
Contact input
1-point external switch input, which can be used for clearing, tareing, allowing alarm, display locking, clearing peak and valley value, and capturing function (can be selected by parameters)

 

Reviews

There are no reviews yet.

Be the first to review “Digital weighing indicator DY910 series”

Your email address will not be published.

Customize your Own sensors

Just write down some details and our our customer service get back to you in a jiffy!